So I got a couple days off and when I arrived home there were a lot of parts waiting on me.
Transformers, case, sockets.
I got to work.
The first thing I did was put some components on the eyelet board to see what the layout would be like.
Next I looked at the case and how the components would relate to the tubes keeping in mind the shorter the leads the better.
The layout was completed but remember things change constantly.
The valve sockets were installed. This entailed using a knock out for each hole.
Installation of transformers was not set in stone.
All the front panels jacks, pots, switches were installed.
Till next time.
See ya.